COOLER THERMISTOR INSTALLATION

PROCEDURE


  1. INSTALL HEIGHT CONTROL COMPRESSOR THERMISTOR ASSEMBLY


    1. B006CN0

      Attach the clamp to install the height control compressor thermistor assembly.

    2. Connect the connector.

  2. INSTALL W/O RELAY COMPRESSOR & DRYER ASSEMBLY

    Click here

  3. AIR CHARGING

    Click here

    Tech Tips


    • Make sure to use the nitrogen gas injector (SST) and adapter (SST).

    • Select an adapter (SST) that matches the standard of the nitrogen cylinder and install it.

    • The adapter (SST) is not required for JIS standard.

    SST
    09761-50010
    09761-05040

  4. CHECK CONNECTIONS OF TUBES FOR AIR LEAKAGE

    Click here

  5. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

    2. Measure the vehicle height.

      Click here

  6. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.

  7. CHECK HEIGHT CHANGE OPERATION

    Click here