TRAP CANISTER(w/ Canister Pump Module) INSPECTION

PROCEDURE


  1. INSPECT TRAP CANISTER WITH CANISTER PUMP MODULE


    1. B008HK6

      Check the canister pump module.


      1. Connect a positive (+) lead from the battery to terminal 5 and a negative (-) lead to terminal 1.

      2. Check that a clicking sound is heard from the canister pump module.

        If the result is not as specified, replace the canister pump module.

    2. B008GYS

      Visually check the trap canister with canister pump module for cracks or damage.

      If cracks or damage is found, replace the trap canister with canister pump module or canister pump module.

    3. B008H3EC01
      *a Air Inlet Line Port
      *b Connector
      *c Fuel Vent Hose Sub-assembly
      B008IUL Air

      Check the trap canister operation.


      1. With the connector closed, blow air at 5 kPa (0.1 kgf/cm2, 0.7 psi) into the air inlet line port and check that air flows from the fuel vent hose sub-assembly.

        If the result is not as specified, replace the trap canister with canister pump module.

    4. Check for air leaks.

      Click here


      1. Remove the charcoal canister assembly.

        Click here

      2. Inspect the charcoal canister assembly.

        Click here

      3. Connect the trap canister with canister pump module to the charcoal canister assembly.

      4. B008HMJC01
        *a Vent Line Port
        *b Air Inlet Line Port
        *c Purge Line Port
        *d Connector
        *e Pressure Gauge

        Connect a pressure gauge to the vent port of the canister.

      5. With the purge line port, air inlet line port and connector closed, apply pressurized air at 19.6 kPa (0.2 kgf/cm2, 2.8 psi) into the vent line port, and then confirm that pressure is retained for 1 minute.

        If the result is not as specified, replace the trap canister with canister pump module.

      6. Disconnect the trap canister with canister pump module to the charcoal canister assembly.

      7. Install the charcoal canister assembly.

        Click here