REAR SPEED SENSOR INSTALLATION

PROCEDURE

1. INSTALL SKID CONTROL SENSOR WIRE

   1. Install the 2 sensor clamps with the 2 bolts.

      13 N*m

      127 kgf*cm

      9 ft.*lbf

      Note:

      Make sure the clamp rotation stopper touches the installation position.

   2. Connect the connector.

      Note:

      Securely connect the connector.

   3. Attach the connector.

   4. Attach the 8 clamps.

      Note:

      When attaching the clamps, do not twist the wire harness.

2. INSTALL REAR SPEED SENSOR LH

   1. Install the speed sensor with the nut.

      7.8 N*m

      80 kgf*cm

      69 in.*lbf

      Note:

      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the axle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle.

      • Make sure there is no foreign matter attached to the speed sensor rotor.

   2. Connect the speed sensor connector.

      Note:

      Securely connect the connector.

3. INSTALL REAR SPEED SENSOR RH

   Tip:

   Use the same procedure described for the LH side.

4. INSTALL REAR WHEEL

   Click here

5. CHECK SPEED SENSOR SIGNAL

   1. Check the speed sensor signal (Click here).