MASS AIR FLOW METER(w/ Glow Plug Controller) ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

   1. Read the value using the GTS (MAF).

      Note:

      Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

      1. Connect the GTS to the DLC3.

      2. Start the engine.

      3. Turn the GTS on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

         Powertrain > Engine and ECT > Data List

         Tester Display
         MAF

      5. Wait for 30 seconds, and read the value on the GTS.

         Standard Condition

         Tester Display	Condition	Specified Condition
         MAF	Idling	3 to 10 gm/sec
         	2000 rpm	10 to 25 gm/sec
         	3000 rpm	30 to 50 gm/sec

         If the result is not as specified, replace the mass air flow meter sub-assembly.

         If the result is within the specified range, inspect the mass air flow meter sub-assembly.

         Click here