HORN REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the horn assembly removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Front television camera view adjustment Panoramic view monitor system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. for Sports Package:

      Click here

    2. except Sport Package:

      Click here

  2. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR

    Click here

  3. REMOVE HIGH PITCHED HORN ASSEMBLY


    1. B006BXGC01
      B006AHR Bolt
      B006EC9 Connector

      Type A:


      1. Remove the bolt and high pitched horn assembly.

      2. Disconnect the connector.

    2. B006ASFC01
      B006AHR Bolt
      B006EC9 Connector

      Type B:


      1. Remove the bolt and high pitched horn assembly.

      2. Disconnect the connector.

  4. REMOVE LOW PITCHED HORN ASSEMBLY


    1. B006GQAC01
      B006AHR Bolt
      B006EC9 Connector

      Type A:


      1. Remove the bolt and low pitched horn assembly.

      2. Disconnect the connector.

    2. B006EZNC01
      B006AHR Bolt
      B006EC9 Connector

      Type B:


      1. Remove the bolt and low pitched horn assembly.

      2. Disconnect the connector.