CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL AIRBAG ECU ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Using SST, install the airbag ECU assembly with the 3 bolts.

      SST
      09961-00950
      A005AF6E02
      Text in Illustration
      *a Fulcrum Length - -
      Torque:
      without SST
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }
      with SST
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Note


      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • This torque value is effective when SST is parallel to a torque wrench.

      • If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.

    4. A005BGCE02
      Text in Illustration
      *1 Waterproof Sheet

      Connect the connectors to the airbag ECU assembly as shown in the illustration.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installation parts of the airbag ECU assembly.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL DECK FLOOR BOX RH

    Click here

  5. INSTALL REAR DECK FLOOR BOX

    Click here

  6. INSTALL NO. 1 DECK BOARD

    Click here

  7. INSTALL NO. 2 DECK BOARD

    Click here

  8. INSTALL DECK BOARD ASSEMBLY

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here