FRONT DOOR SPEAKER REMOVAL

PROCEDURE


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  4. REMOVE DOOR ARMREST COVER

    Click here

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. A005ELM

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 4 rivet heads and remove the front No. 1 speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.