REAR WIPER MOTOR INSTALLATION

PROCEDURE

  1. INSTALL REAR WIPER MOTOR ASSEMBLY

    1. Attach the 2 guides and temporarily install the rear wiper motor assembly with the 3 bolts.

    2. Tighten the 3 bolts.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

    3. Connect the connector.

  2. INSTALL REAR WIPER ARM

    1. E199088C01

      *1

      Wiper Arm Pivot Serrations

      Clean the wiper arm serrations.

    2. E199087C01

      *1

      Wiper Pivot Serrations

      *2

      Wire Brush

      Clean the wiper pivot serrations with a wire brush.

    3. Operate the rear wiper and stop the rear wiper motor at the automatic stop position.

      Tip:

      The wiper motor does not operate if the back door and back door glass are not closed.

    4. E206164C01

      *1

      Ceramic Dot

      *a

      Upper Limit

      *b

      Lower Limit

      Align the blade tip with the mark on the glass as shown in the illustration.

      Standard

      Area

      Standard Condition

      a

      10.0 mm (0.394 in.)

      b

      10.0 mm (0.394 in.)

    5. Install the rear wiper arm with the nut.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

      Tip:

      Hold the wiper arm by hand while tightening the nut.

  3. INSTALL REAR WASHER NOZZLE SUB-ASSEMBLY

    Click here

  4. INSTALL REAR SPOILER SUB-ASSEMBLY

    Click here

  5. INSTALL REAR SPOILER COVER RH

    Click here

  6. INSTALL REAR NO. 1 SPOILER COVER

    Click here