BACKUP BOOST CONVERTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during eco run vehicle converter assembly removal/installation are shown below.

Replacement Part Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate

Click here

Note


  • When the torsion bar is removed, the tension in the torsion bar disappears and the luggage compartment door closes with strong force. Therefore, hold the luggage compartment door when opening or closing the luggage compartment door.

  • Because the torsion bar at the RH side is on the top and the torsion bar at the LH side is on the bottom, install from RH → LH and remove from LH → RH.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE TOOL BOX

    Click here

  4. REMOVE LUGGAGE COMPARTMENT TRIM BOX (w/ Luggage Compartment Trim Box)

    Click here

  5. REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER

    Click here

  6. REMOVE ECO RUN VEHICLE CONVERTER ASSEMBLY


    1. B006EYI

      Remove the 2 nuts.

    2. B006E8MC01
      *a Lever
      B006DHE Open in this Direction

      Open the lever while pushing the locks on the lever and disconnect the connector and remove the eco run vehicle converter assembly.