KNEE AIRBAG ASSEMBLY(for Sedan) INSTALLATION

PROCEDURE

  1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    1. Engage the 8 hooks to install the lower No. 1 instrument panel airbag assembly to the lower No. 1 instrument panel airbag door.

  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY WITH DOOR

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B324556C03

      *a

      Airbag Connector

      *b

      Airbag Connector Lock

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly with door.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the airbag connector lock to install the airbag connector.

    5. Engage the 7 claws and 2 guides to temporarily install the lower No. 1 instrument panel airbag assembly with door.

    6. Install the 4 bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:

      Confirm that the lower No. 1 instrument panel airbag assembly with door is installed securely without any excessive gaps and is not protruding outward.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

    Click here

  4. INSTALL NO. 1 SWITCH HOLE BASE (for LHD)

    Click here

  5. INSTALL NO. 1 SWITCH HOLE BASE (for RHD)

    Click here

  6. INSTALL NO. 2 SWITCH HOLE BASE (for RHD without Entry and Start System)

    Click here

  7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  8. INSTALL NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    Click here

  9. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  10. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for LHD)

    Click here

  11. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

    Click here

  12. INSTALL NO. 2 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    Click here

  13. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  14. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  16. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  17. INSPECT SRS WARNING LIGHT

    Click hereClick here