REAR CENTER SEAT ASSEMBLY(for Rear No. 1 Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

  1. INSTALL REAR CENTER SEAT ASSEMBLY

    1. B224711

      Place the rear center seat assembly in the cabin.

      Note:

      Be careful not to damage the vehicle body or rear No. 1 seat assembly.

    2. Temporarily install the 2 bolts.

    3. Operate the rear center back lock control lever and raise the seatback.

    4. Lift up the seat track adjusting handle and move the seat to the foremost position.

    5. B223981

      Temporarily install the 2 bolts.

    6. B220909E03

      Tighten the 4 bolts in the order shown in the illustration.

      37 N*m

      377 kgf*cm

      27 ft.*lbf

    7. B223279

      Connect the connector.

    8. Attach the wire harness clamp by attaching the 2 claws.

    9. B224709

      Operate the rear back lock control lever RH and raise the rear No. 1 seatback LH.

  2. INSTALL REAR SEAT INNER TRACK BRACKET COVER LH

    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. B223278

      Attach the guide and 3 claws to install the cover.

  3. INSTALL REAR SEAT INNER TRACK BRACKET COVER RH

    Tip:

    Use the same procedures described for the LH side.

  4. INSTALL INNER SEAT TRACK BRACKET COVER LH

    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. B223276

      Attach the 3 guides and 2 claws to install the cover.

  5. INSTALL INNER SEAT TRACK BRACKET COVER RH

    Tip:

    Use the same procedures described for the LH side.