REAR SEAT OUTER BELT ASSEMBLY INSTALLATION


  1. INSTALL REAR NO. 1 SEAT BELT ASSEMBLY OUTER LH

    A01DXNGE02

    1. Align the claws with the seat belt positioning holes and install the ELR of the seat belt with the bolt as shown in the illustration.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf, for bolt A }
      Torque:
      4.8 N*m  { 49 kgf*cm, 42 in.*lbf, for bolt B }
    2. A01E2ZNE02

      Install the bolt and close the cover as shown in the illustration.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. A01DXK5E02

      Install the floor anchor with the bolt, as shown in the illustration.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    4. A01DZ3NE01

      Install the floor anchor with the bolt, as shown in the illustration.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL QUARTER TRIM PANEL LOWER LH (for Double Cab)


    1. w/o Rear Center Seat Belt:


      1. Attach the 3 clips and claw to install the lower quarter trim panel LH.

    2. w/ Rear Center Seat Belt:


      1. Attach the 3 clips and claw to install the lower quarter trim panel LH.

  3. INSTALL REAR DOOR OPENING TRIM LH (for Double Cab)

  4. INSTALL REAR DOOR SCUFF PLATE LH (for Double Cab)


    1. Attach the 2 clips and 7 claws to install the rear door scuff plate LH.

  5. INSTALL REAR SEAT ASSEMBLY (for Extra Cab)


    1. A01DV67

      Attach the 2 hooks.

    2. A01DVFP

      Attach the hook to install the rear seat cushion assembly LH.

  6. INSTALL QUARTER INSIDE TRIM BOARD LH (for Extra Cab)


    1. Attach the 7 clips, 3 guides and 4 claws to install the quarter inside trim board.

    2. Connect the front seat outer belt floor anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  7. INSTALL REAR SEAT CUSHION ASSEMBLY RH (for Extra Cab)


    1. A01DV67

      Attach the 2 hooks.

    2. A01DVFP

      Attach the hook to install the rear seat cushion assembly LH.

  8. INSTALL REAR SEAT CUSHION ASSEMBLY LH (for Extra Cab)

    Tech Tips

    Use the same procedures described for the LH side.

  9. INSTALL REAR SEAT ASSEMBLY (for Double Cab)


    1. Install the rear seat assembly Click here.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.