REAR LIGHT ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR LIGHT END RUBBER


    1. B005V2AC01
      B006GBM Area to Clean

      Clean the application area of the rear light end rubber shown in the illustration.

      Note

      Remove any remaining double-sided tape, and then clean and degrease the area.

    2. Remove approximately 30 mm (1.18 in.) of the peeling tape from a new rear light end rubber.

    3. Align the rear light end rubber with the application start position and set it.

      B005XAQC01
      *a Application Start Position - -
    4. B005VWMC01
      B006DHE Install in this Direction

      While peeling the peeling tape, align the rear light end rubber to the curve and set it.

    5. B005U0UC01
      B006DHE Press Here

      Press the set portion of the part with your finger to secure it.

      Note

      Do not slide your finger horizontally, as doing so may stretch the part unnecessarily.

  2. INSTALL REAR LIGHT LED


    1. B005TQXC01
      B006DHE Clockwise

      Set the rear light LED into place and turn it clockwise until it stops to install it.

    2. B005UH6

      Install the screw.

    3. Connect the connector.

  3. INSTALL REAR LIGHT GASKET


    1. B005QMU

      Install a new rear light gasket.

  4. INSTALL REAR LIGHT GASKET LH


    1. B005RS8

      Install a new rear light gasket LH.

  5. INSTALL REAR LIGHT PACKING LH


    1. B005W23

      Install a new rear light packing LH.