REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

Note


  • Because the RH side flexible hose and LH side flexible hose are not interchangeable, verify the part number when installing the rear flexible hoses.

  • If the rear flexible hose are to be rused, connect them after checking the identification marks placed when each hose was disconnected.

PROCEDURE


  1. INSTALL REAR FLEXIBLE HOSE LH


    1. Connect the rear flexible hose LH with a new gasket and a new union bolt to the rear disc brake cylinder assembly LH.

      Torque:
      30.4 N*m  { 310 kgf*cm, 22 ft.*lbf }

      Tech Tips

      Install the flexible hose lock securely in the lock hole in the rear disc brake cylinder assembly LH.

    2. Install a new clip to the rear flexible hose LH.

      Note

      Install the clip as far as it will go.

    3. A01XMWUC02
      *a Torque Wrench Fulcrum Length

      Using a union nut wrench, connect the rear flexible hose LH to the brake tube while holding the rear flexible hose LH with a wrench.

      Torque:
      Specified tightening torque
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter as dirt and dust to enter the brake tube from the connecting point.

  2. BLEED BRAKE LINE

    Click here

  3. INSTALL REAR WHEEL

    Click here