LANE DEPARTURE ALERT BUZZER(for RHD) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  3. REMOVE UPPER INSTRUMENT PANEL

    Click here

  4. REMOVE DEFROSTER NOZZLE ASSEMBLY

    Click here

  5. REMOVE HEATER TO REGISTER DUCT ASSEMBLY

    Click here

  6. REMOVE SKID CONTROL BUZZER ASSEMBLY (LANE DEPARTURE ALERT BUZZER)

    B357148

    1. Detach the clamp.

    2. Disconnect the connector and remove the skid control buzzer assembly (lane departure alert buzzer).