ECD SYSTEM(for Swirl Control Valve), Diagnostic DTC:P1220

DTC Code DTC Name
P1220 Over Temperature of Device Driver of Metering Unit

DESCRIPTION

The fuel quantity control valve is installed to the fuel supply pump assembly. The fuel quantity control valve is controlled using pulse-width modulated signals. When the fuel control system is operating, the ECM controls the fuel quantity control valve using multiple pulse duty ratios. The system adjusts the rail pressure to the standard level calculated by the ECM.

DTC No.

DTC Detection Condition

Trouble Area

P1220

Overtemperature detected in fuel quantity control valve circuit for 0.2 seconds.

(3 trip detection logic)

  • Cooling fan system

  • ECM

WIRING DIAGRAM

Refer to DTC P0001 (Click here).

CAUTION / NOTICE / HINT

Note:

  • When replacing the ECM, the ECM needs Registration and Initialization (Click here).

Tip:

  • When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

  • Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE

  1. PERFORM ACTIVE TEST USING GTS (ACTUATOR TEST OF FAN HIGH SPEED AND LOW SPEED)

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Actuator Test of Fan High Speed and Actuator Test of Fan Low Speed.

      OK

      Cooling fan operates according to operation.

    REPAIR OR REPLACE COOLING FAN SYSTEMClick here

  2. REPLACE ECM

    1. Replace the ECM (Click here).

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIREDClick here

  3. REPAIR OR REPLACE COOLING FAN SYSTEM

    1. Repair or replace the cooling fan system (Click here).

  4. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs (Click here).

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.

    END