NAVIGATION SYSTEM(for DVD) Voice is not Recognized
| DTC Code | DTC Name |
|---|---|
| Voice is not Recognized |
PROCEDURE
CHECK NAVIGATION SETTING
-
Enter the "Setup" screen by pressing the "Setup" switch.
Select "Voice".
Check that "Voice Recognition Guidance" is not "Off".
OK
"Voice Recognition Guidance" is not "Off".
Result
Result
OK
NG
NG TURN "Voice Recognition Guidance" ON
-
CHECK MAP DISC
-
Check that the map disc is not deformed or cracked.
OK
No deformations or cracks in the map disc.
Result
Result
OK
NG
NG REPLACE MAP DISC
-
CHECK MAP DISC
-
Check for dirt on the map disc surface.
OK
No dirt is on the map disc surface.
Tip:If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.
Note:Do not use a conventional record cleaner or anti-static preservative.
Result
Result
OK
NG
NG CLEAN MAP DISC
-
CHECK MICROPHONE (OPERATION CHECK)
-
*a
Microphone Input Level Meter
*b
Recording Switch
*c
Stop Switch
*d
Play Switch
*e
Recording Indicator
Enter "Microphone&Voice Recognition Check" (Check Mic & Voice Recognition).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
Tip:Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
Voice can be recorded for up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
OK
All check results are normal.
Result
Result
OK
NG
-