ENTRY AND START SYSTEM(for Start Function) Power Source Mode does not Change to ON (ACC)

DTC Code DTC Name
Power Source Mode does not Change to ON (ACC)

DESCRIPTION

If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode.

Table 1. Related Data List and Active Test Items

Problem Symptom

Data List Item

Active Test Item

Power source mode does not change to on (ACC) but does change to on (IG)

  • Power Source Control

  • Power Supply Condition

  • ACC Relay Monitor

-

WIRING DIAGRAM

Refer to "Power Source Mode does not Change to on (IG and ACC)".

Click hereClick hereClick hereClick here

CAUTION / NOTICE / HINT

Note:

  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • The entry and start system (for Start Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

    Click hereClick here

  • Make sure that no DTCs are output. If any DTCs are output, proceed to the Diagnostic Trouble Code Chart.

    Click hereClick hereClick hereClick hereClick hereClick here

  • If the entry and start system is disabled through the customize function, enable the system before performing troubleshooting.

    Click hereClick hereClick here

  • Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Start Function) precaution.

    Click hereClick here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

  • After completing repairs, confirm that the problem does not occur.

Tip:

When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

    Click here

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

    Click here

    Result

    Result

    Proceed to

    OK

    A

    NG (for LHD)

    B

    NG (for RHD)

    C
    B

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

    Click hereClick here

    C

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

    Click hereClick here

    A

  3. INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (SMART KEY ECU ASSEMBLY)

    Click here

    Result

    Proceed to

    OK

    NG
    OK

    CHECK RELAY CONTACT SIDE CIRCUIT

    NG

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)