SUN GEAR AND ONE-WAY CLUTCH DISASSEMBLY


  1. INSPECT ONE-WAY CLUTCH ASSEMBLY

    A01E2GLE01

    1. Hold the planetary sun gear, and turn the one-way clutch assembly. Check that the one-way clutch hub can be turned freely clockwise and locks when turned counterclockwise.

  2. REMOVE ONE-WAY CLUTCH ASSEMBLY

    A01DZHNE01

  3. REMOVE NO. 1 ONE-WAY CLUTCH THRUST WASHER

    A01DVHSE01

  4. REMOVE SUN GEAR SHAFT OIL SEAL RING

    A01DW5JE01

    1. Remove the 2 oil seal rings from the sun gear input drum.

  5. REMOVE SUN GEAR INPUT DRUM

    A01DY49E01

    1. Use a wooden block or similar object as a work stand.

    2. Using snap ring pliers, remove the snap ring.

    3. Remove the input drum from the planetary sun gear.

  6. REMOVE SUN GEAR INPUT DRUM SHAFT SNAP RING

    A01DXSJE01

    1. Using a screwdriver, pry out the snap ring from the planetary sun gear.

  7. INSPECT PLANETARY SUN GEAR

    A01E0FNE01

    1. Using a dial indicator, measure the inside diameter of the planetary sun gear bushes.

      Maximum inside diameter
      27.08 mm (1.0661 in.)

      If the inside diameter is greater than the maximum, replace the planetary sun gear.