STOP AND START SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

*: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Result

    Proceed to

    NEXT
    NEXT

  3. PRE-CHECK

    1. Measure the battery voltage.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      Tip:

      • Whether the vehicle battery is discharged can be checked simply by operating the horn.

      • After recharging the battery, using the GTS, initialize the integrated current item*.

        *: If the Data List item "Integrated Current" indicates 0 or more, initialization is not necessary.

    2. Check the fuses and relays.

    3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

    Result

    Proceed to

    NEXT
    NEXT

  4. CHECK DTC AND FREEZE FRAME DATA*

    1. Check for DTCs.

      Click here

      Powertrain > Stop and Start > Trouble Codes

    2. Check for freeze frame data.

      Tip:

      Record or print DTCs and freeze frame data if necessary.

    3. Clear the DTCs and freeze frame data.

      Click here

      Powertrain > Stop and Start > Clear DTCs

    4. Recheck for DTCs.

      Click here

      Powertrain > Stop and Start > Trouble Codes

      Tip:

      If any DTCs for the CAN communication system are output, troubleshoot those DTCs first.

      Result

      Result

      Proceed to

      DTCs are not output

      A

      DTCs are output

      B
    B

    GO TO DTC CHART

    Click hereClick hereClick here

    A

  5. PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table.

      Click hereClick hereClick here

      Result

      Result

      Proceed to

      Fault is not listed in problem symptoms table

      A

      Fault is listed in problem symptoms table

      B
    B

    REPAIR OR REPLACEClick here

    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Data List / Active Test

      Click hereClick here

    2. Terminals of ECU

      Click hereClick hereClick here

    Result

    Proceed to

    NEXT
    NEXT

  7. REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  8. CONFIRMATION TEST

    1. Warm up the engine.

    2. Turn the air conditioning system off.

    3. Drive the vehicle for 15 to 40 minutes.

    4. Stop the vehicle, move the shift lever to neutral and release the clutch pedal. Check if the engine is stopped by the stop and start control.

      Tip:

      If the engine is not stopped by stop and start control, air fuel ratio learning and idle speed learning are necessary. Allow the engine to idle for 3 minutes and check that the engine idle speed is within 50 rpm of the target idle speed.

    5. Depress the clutch pedal and that the engine restarts.

    Result

    Proceed to

    NEXT
    NEXT

    END