GENERATOR INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   
   

   1. Using an E8 "TORX" socket wrench, temporarily install the generator assembly with the 2 stud bolts.

   2. Tighten the 2 stud bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

   3. Install the 2 bolt and 2 nuts.

      Torque:

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

   4. Connect the engine wire to the terminal B with the nut.

      Torque:

      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

   5. Connect the generator assembly connector.

   6. Connect wire harness and install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

   7. Install the terminal cap.

   8. Attach the clamp.

   9. Connect the engine wire with the bolt.

      Torque:

      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

2. INSTALL AIR CLEANER SUPPORT BRACKET ASSEMBLY

   
   

   1. Install the air cleaner support bracket assembly with the 2 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

3. INSTALL NO. 3 ENGINE WIRE

   Click here

4. INSTALL FAN AND GENERATOR V BELT

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here