SHIFT PADDLE SWITCH INSTALLATION

PROCEDURE

1. INSTALL NO. 1 SWITCH WIRE

   Tech Tips

   Perform this procedure only when replacement of the No. 1 switch wire is necessary.

   
   

   1. Engage the 6 clamps to install the No. 1 switch wire to the steering wheel assembly.

   2. Engage the 2 guides.

   3. Connect the steering vibration and heater ECU connector.

2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

   
   

   1. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors.

   2. Engage the 2 claws to install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly.

   3. Install 2 new screws.

      Torque:

      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }

3. INSTALL LOWER NO. 1 STEERING WHEEL BOSS COVER

   
   

   1. Engage the 2 claws to install the 2 lower No. 1 steering wheel boss covers to the steering wheel assembly.

   2. Install 2 new screws.

      Torque:

      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }

4. INSTALL STEERING PAD SWITCH ASSEMBLY

   Click here

5. INSTALL CRUISE CONTROL MAIN SWITCH

   Click here

6. INSTALL STEERING WHEEL ASSEMBLY

   Click here