NETWORK GATEWAY ECU(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  4. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  5. REMOVE REAR CONSOLE ARMREST ASSEMBLY

    Click here

  6. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

  7. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  9. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  10. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  11. REMOVE ECU INTEGRATION BOX RH

    Click here

  12. REMOVE NETWORK GATEWAY ECU


    1. Detach the 2 claws and remove the network gateway ECU.

      B008GNJ