WASHER LEVEL WARNING SWITCH INSPECTION

PROCEDURE

  1. INSPECT WASHER LEVEL WARNING SWITCH

    Tip:

    This check should be performed with the level warning switch assembly installed on the washer jar.

    1. E158668C16

      *a

      Component without harness connected

      (Level Warning Switch Assembly)

      Fill the washer jar with washer fluid.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      1 (S) - 2 (E)

      Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher*

      10 kΩ or higher

      Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower*

      Below 1 Ω
      Tip:

      *: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.

      If the result is not as specified, replace the level warning switch assembly.