CLUTCH UNIT(for EA66) REMOVAL

PROCEDURE

  1. REMOVE MANUAL TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY

    1. C113576

      Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transaxle assembly.

  3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY

    1. C116601

      Remove the clutch release bearing assembly and release bearing hub clip from the clutch release fork sub-assembly.

  4. REMOVE RELEASE FORK SUPPORT

    1. C304173

      Remove the release fork support from the manual transaxle assembly.

      Tip:

      If there is adhesive on the threaded portion of the release fork support,replace a release fork support and clean the threaded potion of the housing.

  5. REMOVE CLUTCH RELEASE FORK BOOT

    1. C274613

      Remove the clutch release fork boot from the manual transaxle assembly.

  6. REMOVE CLUTCH COVER ASSEMBLY

    1. C274614C01

      *a

      Matchmark

      Align the matchmark on the clutch cover assembly with the one on the flywheel sub-assembly.

    2. Loosen each bolt 180° at a time until the spring tension is released.

      Note:

      Following the order in the illustration, make sure to uniformly loosen the bolts 180° at a time.

    3. Remove the 6 bolts and pull off the clutch cover assembly.

      Note:

      Do not drop the clutch disc assembly.

  7. REMOVE CLUTCH DISC ASSEMBLY

    Note:

    Keep the lined part of the clutch disc assembly, the pressure plate, and the surface of the flywheel sub-assembly away from oil and foreign matter.