CRUISE CONTROL MAIN SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE STEERING PAD

    Click here

  4. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY

    1. B223913E02

      Put protective tape around the switch.

      Table 1. Text in Illustration

      *a

      Protective Tape
    2. B437910E01

      Disconnect the connector.

      Table 2. Text in Illustration

      *a

      Protective Tape

    3. Remove the 2 screws and switch.