ПЕРВИЧНЫЙ ВАЛ СНЯТИЕ


  1. REMOVE NO. 2 SYNCHRONIZER RING

    A01DY5LE01

    1. Remove synchronizer ring from the input shaft.

  2. REMOVE INPUT SHAFT BEARING

    A01DWUGE01

    1. Remove the bearing from the input shaft.

  3. REMOVE FRONT BEARING SHAFT SNAP RING

    A01E0DNE01

    1. Using a snap ring expander, remove the snap ring from the input shaft.

  4. REMOVE INPUT SHAFT FRONT BEARING

    A01E0IKE01

    1. Using SST and a press, press out the front bearing from the input shaft.

      SST
      09950-00020

  5. REMOVE NO. 2 SYNCHRONIZER RING

    A01DX84E01

    1. Apply gear oil to the cone of the input shaft, and check that it does not turn in both direction while pushing the No. 2 synchronizer ring.

      If it can turn, replace the No. 1 synchronizer ring .

    2. A01DYLPE01

      Push the No. 2 synchronizer ring to the cone of the input shaft. Measure the clearance between the No. 2 synchronizer ring and input shaft.

      Standard clearance
      0.70 to 1.70 mm (0.0276 to 0.0669 in.)

      If the clearance is not as specified, replace the synchronizer ring No. 2 with a new one.