GLOW PLUG ON-VEHICLE INSPECTION

PROCEDURE

  1. REMOVE NO. 1 GLOW PLUG CONNECTOR

    Click here

  2. INSPECT GLOW PLUG ASSEMBLY

    1. A297109

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      Glow plug terminal - Body ground

      20°C (68°F)

      0.28 Ω or higher

      If the result is not as specified, replace the glow plug assembly.

      Note:

      • Be careful not to damage the glow plug assembly as this may cause an open circuit or shorten the life of the glow plugs.

      • Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.

      • Clean any oil on the terminal and bakelite washer with a dry cloth.

  3. INSTALL NO. 1 GLOW PLUG CONNECTOR

    Click here