FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

1. INSTALL TIMING CHAIN COVER OIL SEAL

   1. 

      Apply MP grease to the lip of a new timing chain cover oil seal.

      Note:

      • Do not allow foreign matter to contact the lip of the timing chain cover oil seal.

      • Do not allow MP grease to contact the timing chain cover oil seal.

   2. Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

      09223-22010

      Note:

      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the timing chain cover oil seal at an angle.

2. INSTALL CRANKSHAFT PULLEY

   1. 

      *a	Hold
      	Turn

      Align the key groove of the crankshaft pulley with the pulley set key.

   2. Temporarily install the crankshaft pulley with the pulley bolt.

   3. Using SST, hold the crankshaft pulley in place and tighten the pulley bolt.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      09213-58014

      91551-80840

      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      09213-54015

      09330-00021

      190 N*m

      1937 kgf*cm

      140 ft.*lbf

      Tip:

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

3. INSTALL V-RIBBED BELT

   Click here

4. ADJUST V-RIBBED BELT

   Click here

5. INSPECT V-RIBBED BELT

   Click here

6. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

   Click hereClick here

7. ADD ENGINE OIL

   Click here

8. INSPECT FOR OIL LEAK

   Click here

9. INSTALL REAR ENGINE UNDER COVER RH

   Click hereClick here

10. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

11. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here