REAR VIEW MONITOR SYSTEM(for Sedan)

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the rear view monitor system.

  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    1. Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

      Tip:

      The rear view monitor display may be temporarily distorted due to radio waves around the vehicle.

      Problem Symptom

      Cause

      • Both of the following conditions are met:

      • The problem symptom indicates a rear view monitor display malfunction and the problem symptom cannot be reproduced.

      • DTC C1622 is output as "Hist" only.*

      The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.

      *: DTCs output as "Hist" will not be output again after DTCs are cleared.

    Result

    Proceed to

    NEXT
    NEXT

  3. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage.

      Standard Voltage

      11 to 14 V

      Tip:

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT
    NEXT

  4. CHECK FOR DTC*

    1. Check for DTCs and make a note of any codes that are output.

      Click here

      Body Electrical > Navigation System > Trouble Codes

    2. Clear the DTCs.

      Click here

      Body Electrical > Navigation System > Clear DTCs

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Click here

      Body Electrical > Navigation System > Trouble Codes

    Result

    Result

    Proceed to

    No DTCs are output

    A

    DTCs are output

    B
    B

    ADJUST, REPAIR OR REPLACEClick here

    A

  5. PROBLEM SYMPTOM CONFIRMATION

    Result

    Result

    Proceed to

    Symptom does not occur

    A

    Symptom occurs

    B
    B

    CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEMClick here

    A

  6. SYMPTOM SIMULATION

    Result

    Proceed to

    NEXT
    NEXT

  7. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM

    1. Refer to audio and visual system (for Sedan Radio and Display Type).*1

      Click hereClick here

    2. Refer to navigation system (for Sedan).*2

      Click hereClick hereClick here

      • *1: w/o Navigation System

      • *2: w/ Navigation System

    Result

    Result

    Proceed to

    Symptom does not appear

    A

    Symptom appears (w/o Navigation System)

    B

    Symptom appears (w/ Navigation System)

    C
    B

    GO TO AUDIO AND VISUAL SYSTEM (for Sedan Radio and Display Type)

    Click hereClick here

    C

    GO TO NAVIGATION SYSTEM (for Sedan)

    Click hereClick hereClick here

    A

  8. PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table.

      Click here

      Result

      Result

      Proceed to

      Fault is not listed in Problem Symptoms Table

      A

      Fault is listed in Problem Symptoms Table

      B
    B

    ADJUST, REPAIR OR REPLACEClick here

    A

  9. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

    1. Terminals of ECU.

      Click here

    2. Diagnosis System

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  10. ADJUST, REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  11. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END