FRONT LOWER SUSPENSION ARM(for RH Side) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

For models with a 1AD-FTV or 1ND-TV engine, the front lower No. 1 suspension arm sub-assembly RH can be installed without removing the front suspension crossmember sub-assembly.

PROCEDURE

  1. TEMPORARILY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH (for 1NR-FE)

    Click here

  2. TEMPORARILY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH (for 1ZR-FAE)

    Click here

  3. TEMPORARILY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH (for 1AD-FTV, 1ND-TV)

    1. Temporarily install the front lower No. 1 suspension arm sub-assembly RH to the front suspension crossmember sub-assembly with the 2 bolts and nut.

      Note:

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  4. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH (for 1AD-FTV, 1ND-TV)

    1. Connect the front lower No. 1 suspension arm sub-assembly RH to the front lower ball joint assembly with the bolt and 2 nuts.

      89 N*m

      908 kgf*cm

      66 ft.*lbf

      Note:

      Do not damage the boot of the ball joint.

  5. INSTALL FRONT WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  6. STABILIZE SUSPENSION

    Click here

  7. FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

    1. C273737C01

      *a

      Length of SST 200 mm (7.87 in.)

      *b

      Length of Torque Wrench 425 mm (1.39 ft.)
      V100136

      Turn

      Using SST, fully tighten the bolt A.

      09961-01270

      without SST [Torque (N*m(kgf*cm, ft.*lbf))]

      233 N*m

      2376 kgf*cm

      172 ft.*lbf

      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]

      158 N*m

      1611 kgf*cm

      117 ft.*lbf

      Tip:

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 200 mm (7.87 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 425 mm (1.39 ft.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

    2. Fully tighten the bolt B.

      214 N*m

      2182 kgf*cm

      158 ft.*lbf

      Note:

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  8. INSTALL NO. 1 ENGINE UNDER COVER (for 1AD-FTV, 1ND-TV)

  9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here