METER / GAUGE SYSTEM FREEZE FRAME DATA

  1. FREEZE FRAME DATA

    1. Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.

  2. CHECK FREEZE FRAME DATA

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.

    5. According to the GTS display, select a DTC that stored freeze frame data.

    6. Read the freeze frame data recorded when the DTC was stored.

      Table 1. Combination Meter

      Tester Display

      Condition

      Displayed Item

      B1503

      Exhaust Heat Management Warning Detected

      • Trip

      • Elapsed time after turning the ignition switch to ON

      B1507

      Open in Turn Signal Circuit

      B1508

      Short in Turn Signal / Hazard Flasher Circuit

      U0100

      Lost Communication with ECM / PCM "A"

      U0129

      Lost Communication with Brake System Control Module

      U0131

      Lost Communication with Power Steering Control Module

      U0142*

      Lost Communication with Body Control Module "B"

      U0151

      Lost Communication with Restraints Control Module

      • *: w/o Multi-information display (Segment LCD type)

  3. CLEAR FREEZE FRAME DATA

    Note:

    Clearing the DTCs will also clear the freeze frame data.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Clear DTCs and freeze frame data.

      Click here

      Body Electrical > Combination Meter > Clear DTCs