AUTOMATIC TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note:

If automatic transmission parts are replaced, refer to the Parts Replacement Compensation Table to determine if any additional operations are necessary.

Click here

PROCEDURE

  1. REMOVE DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT

    1. C228929

      Remove the flywheel housing under cover.

    2. C228931N02

      Using SST, hold the crankshaft pulley.

      09213-54015

      09330-00021

      91551-80650

    3. C281370

      Remove the 6 drive plate and torque converter assembly setting bolts.

  2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here

  3. REMOVE STARTER ASSEMBLY

  4. DISCONNECT WIRE HARNESS

    1. Remove the bolt and disconnect the ground cable from the automatic transaxle assembly.

      C280050

    2. Detach the 5 wire harness clamps.

    3. Turn the lock lever and disconnect the connector from the wiring harness connector.

    4. Disconnect the park/neutral position switch connector.

  5. REMOVE WIRE HARNESS CLAMP BRACKET

    1. Remove the 2 bolts and 2 wire harness clamp bracket.

      C280049

  6. REMOVE BREATHER HOSE BRACKET

    1. C228915

      Detach the transmission breather hose sub-assembly from the breather hose bracket.

    2. C228916

      Remove the bolt and breather hose bracket from the automatic transaxle assembly.

  7. REMOVE WIRING HARNESS CONNECTOR

    1. C238952

      Remove the 2 bolts and wiring harness connector from the automatic transaxle assembly.

  8. REMOVE TRANSMISSION OIL COOLER

    1. C280479

      Slide the clips and disconnect the oil cooler inlet hose and oil cooler outlet hose from the automatic transaxle assembly.

    2. Remove the 2 bolts and transmission oil cooler from the front engine mounting bracket.

  9. REMOVE FRONT ENGINE MOUNTING BRACKET

    1. C280053

      Remove the 4 bolts and front engine mounting bracket from the automatic transaxle assembly.

  10. REMOVE REAR ENGINE MOUNTING BRACKET

    1. C280469

      Remove the 3 bolts and rear engine mounting bracket from the automatic transaxle assembly.

  11. REMOVE ENGINE MOUNTING BRACKET LH

    1. C280052

      Remove the 4 bolts and engine mounting bracket LH from the automatic transaxle assembly.

  12. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

    1. C278990

      Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.

  13. REMOVE TRANSMISSION CASE PLUG ASSEMBLY

    1. C201723

      Remove the transmission case plug assembly from the automatic transaxle assembly.

    2. Remove the O-ring from the transmission case plug assembly.

  14. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

    1. C204173

      Remove the 9 bolts and automatic transaxle assembly.

      Note:

      To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine.

  15. REMOVE TORQUE CONVERTER ASSEMBLY

    1. Remove the torque converter assembly from the automatic transaxle assembly.

      Note:

      Make sure to remove the torque converter assembly horizontally from the input shaft.

  16. REMOVE TRANSFER ASSEMBLY

    Click here

  17. REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT

    C287928

    1. Remove the 2 transfer and transaxle setting stud bolts.

      Tip:

      It is not necessary to remove the transfer and transaxle setting stud bolts unless they are being replaced.

  18. INSPECT TORQUE CONVERTER ASSEMBLY

    Click here

  19. INSPECT DRIVE PLATE

    Click here