FRONT DRIVE SHAFT ASSEMBLY(for 2WD) INSPECTION

CAUTION / NOTICE / HINT

Note:

  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE

  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY

    1. C116430

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 joint boots for damage.

    5. C201654C01

      *A

      for LH Side

      *B

      for RH Side

      Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.

      Length (A)

      Item

      Length

      for 2WW (Manual Transaxle)

      LH Side

      565.6 mm (1.86 ft.)

      RH Side

      914.2 mm (3.00 ft.)

      for 2AR-FE (Automatic Transaxle)

      LH Side

      577.6 mm (1.89 ft.)

      RH Side

      914.4 mm (3.00 ft.)

      for 2AR-FE (Manual Transaxle)

      LH Side

      583.6 mm (1.91 ft.)

      RH Side

      906.4 mm (2.97 ft.)

      for 3ZR-FE (Manual Transaxle)

      LH Side

      594.6 mm (1.95 ft.)

      RH Side

      893.4 mm (2.93 ft.)

      for 3ZR-FE (CVT)

      LH Side

      591.2 mm (1.94 ft.)

      RH Side

      890.0 mm (2.92 ft.)
      Note:

      Keep the drive shaft assembly level during inspection.

      If the boots are stretched or contracted, correct them.