REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  2. REMOVE REAR DOOR SERVICE HOLE COVER

    Click hereClick here

  3. REMOVE REAR DOOR LOCK ASSEMBLY

    1. B371399C01

      *a

      Release Plate

      Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Move the rear door lock assembly downward to disconnect it from the release plate of the rear door outside handle frame and remove the rear door lock assembly.

    4. When reusing the rear door lock assembly:

      1. B371401

        Remove the door lock wiring harness seal from the rear door lock assembly.

  4. REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY

    1. B371402

      Using a screwdriver, disengage the 2 claws as shown in the illustration.

    2. B371404

      Disengage the 2 claws to remove the rear door lock cover sub-assembly.

  5. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    1. B371405

      Remove the rear door lock remote control cable assembly as shown in the illustration.

  6. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

    1. B371407

      Remove the rear door inside locking cable assembly as shown in the illustration.