POWER BACK DOOR CONTROL SWITCH(for LHD) INSPECTION

PROCEDURE

  1. INSPECT BACK DOOR CONTROL SWITCH

    1. Check the operation of the back door control switch .

      1. B338150C01

        *a

        Component without harness connected

        (Back Door Control Switch)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Switch Condition

        Specified Condition

        1 - 4

        Back door control switch not pushed

        10 kΩ or higher

        1 - 4

        Back door control switch pushed

        Below 1 Ω

        If the result is not as specified, replace the back door control switch.

    2. B338151C01

      *a

      Component without harness connected

      (Back Door Control Switch)

      Check that the switch illuminates.

      1. Apply auxiliary battery voltage to the back door control switch and check that the LED illuminates.

        OK

        Measurement Condition

        Specified Condition

        Auxiliary battery positive (+) → 3 (ILL+)

        Auxiliary battery negative (-) → 2 (ILL-)

        LED illuminates

        If the result is not as specified, replace the back door control switch.