VACUUM PUMP(for 3ZR-FAE) DISASSEMBLY

PROCEDURE


  1. REMOVE END COVER


    1. A001TCP

      Using a T25 "TORX" socket wrench, remove the 5 screws and end cover.

      Note


      • Hold the vacuum pump assembly so that its installation surface, fitting parts and oil pipe will not be damaged.

      • As the vacuum pump housing deforms when force is applied, do not hold it with a tool such as a vise.

      • Securely fit the T25 "TORX" socket wrench to the screws.

      • Do not drop the end cover.

      • Do not damage the end cover.

    2. A001V26C02
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the No. 1 O-ring.

      Note

      Do not damage the installation groove.

  2. REMOVE VACUUM PUMP VANE


    1. A001VT7

      Remove the vacuum pump vane together with the 2 vacuum pump vane caps.

      Note


      • When reusing the vacuum pump vane and vacuum pump vane caps, make sure to make note of the installation position and orientation.

      • Do not drop the vacuum pump vane and vacuum pump vane caps.

    2. A001VV1C12
      *1 Vacuum Pump Vane Cap
      *2 Vacuum Pump Vane

      Remove the 2 vacuum pump vane caps from the vacuum pump vane.

      Note


      • When reusing the vacuum pump vane and vacuum pump vane caps, make sure to make a note of the installation positions and orientation.

      • Do not drop the vacuum pump vane and vacuum pump vane caps.