BRAKE PEDAL(for LHD) REMOVAL

PROCEDURE

1. REMOVE COMBINATION METER ASSEMBLY

   for Sedan:Click hereClick here

   for Hatchback, Wagon:Click here

2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

   for Sedan:Click hereClick here

   for Hatchback, Wagon:Click here

3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

   for Sedan:Click hereClick here

   for Hatchback, Wagon:Click here

4. REMOVE STOP LIGHT SWITCH ASSEMBLY

   Click here

5. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

   Click here

6. REMOVE BRAKE PEDAL RETURN SPRING

   1. 

      Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.

7. REMOVE PUSH ROD PIN

   1. 

      Remove the clip and push rod pin.

   2. Separate the brake master cylinder push rod clevis from the brake pedal support assembly.

8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

   1. 

      Disengage the claw and slide the wire harness protector from the instrument panel junction block assembly.

   2. Disconnect the connector from the main body ECU and separate the wire harness protector.

   3. 

      Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

   4. 

      Disengage the 2 clamps and separate the wire harness from the brake pedal support assembly.

   5. 

      Remove the 4 nuts and brake pedal support assembly.

   6. 

      Remove the nut from the brake pedal support assembly.