REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

    1. Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.

      60 N*m

      612 kgf*cm

      44 ft.*lbf

      Note:

      Ensure that the contact surfaces are free of foreign matter.

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT REAR AXLE HUB RUNOUT

    Click here

  4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

    Click here

  5. INSTALL REAR SPEED SENSOR

    1. C302687C01

      *a

      45°

      Using a T30 "TORX" socket wrench, install the rear speed sensor to the rear axle hub and bearing assembly with the "TORX" bolt.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

      Note:

      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Firmly insert the rear speed sensor body into the rear axle hub and bearing assembly before tightening the bolt.

      • After installing the rear speed sensor to the rear axle hub and bearing assembly, make sure that there is no clearance between the rear speed sensor stay and rear axle hub and bearing assembly. Also make sure that no foreign matter is stuck between the parts.

      • When turning the speed sensor to insert it, the turning angle should be less than 45° to avoid damaging the O-ring.

    2. Engage the clamp to rear axle beam assembly.

      Note:

      Do not twist the rear speed sensor wire harness when installing it.

  6. ADJUST REAR DRUM BRAKE SHOE CLEARANCE

    Click here

  7. FULLY TIGHTEN HEXALOBULAR SCREW

    Click here

  8. INSTALL REAR WHEEL

    Click here

  9. CHECK FOR SPEED SENSOR SIGNAL

    w/o VSC:Click here

    w/ VSC:Click here