PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1626

Steering Angle Sensor Failure

A fail flag is transmitted from the steering angle sensor

  • Spiral with sensor cable sub-assembly

  • Parking assist ECU

CAUTION / NOTICE / HINT

Note:

  • When "!" mark is displayed on the multi-display after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

    Click here

PROCEDURE

  1. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    1. Replace the spiral with sensor cable sub-assembly with a normally functioning one.

    Result

    Proceed to

    NEXT
    NEXT

  2. CHECK FOR DTC

    1. Clear the DTCs.

      Click here

      Chassis > Panoramic View Monitor > Clear DTCs

    2. Check for DTCs.

      Click here

      Chassis > Panoramic View Monitor > Trouble Codes

      OK

      DTC C1626 is not output.

    Result

    Proceed to

    OK

    NG
    OK

    END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY IS DEFECTIVE)

    NG

    REPLACE PARKING ASSIST ECU

    Click here