DRIVE BELT INSTALLATION

PROCEDURE

  1. INSTALL FAN AND GENERATOR V BELT

    1. A214114N01

      Using SST and a 22 mm wrench, rotate the V-ribbed belt tensioner assembly pulley counterclockwise, and then install the fan and generator V belt.

      09216-42010

      CAUTION:

      • Be careful as the wrench only fits loosely on the V-ribbed belt tensioner assembly tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note:

      • Make sure that the belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

  2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    1. A295895

      Install the front suspension member reinforcement RH with the 4 bolts.

      99 N*m

      1010 kgf*cm

      73 ft.*lbf

  3. INSTALL REAR ENGINE UNDER COVER RH

    1. Install the rear engine under cover RH with the 2 clips.

  4. INSTALL NO. 1 ENGINE UNDER COVER

    Click hereClick here