REAR STABILIZER BAR INSPECTION

PROCEDURE

1. INSPECT REAR STABILIZER LINK ASSEMBLY

   

   Note:

   Since the rear stabilizer link assembly is not reusable, a new part must be installed.

   1. Inspect the turning torque of the ball joint.

      1. Secure the rear stabilizer link assembly in a vise using aluminum plates.

      2. Install the nut to the rear stabilizer link assembly stud.

      3. Move the stud back and forth several times. Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

         Standard Turning Torque

         0.05 to 1.96 N*m (0.5 to 19 kgf*cm, 0.5 to 17 in.*lbf)

         Tip:

         If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

   2. Inspect the dust cover.

      1. Check that the dust cover is not cracked and that there is no grease on it.

         Tip:

         If the dust cover is cracked or there is grease on it, replace the rear stabilizer link assembly with a new one.