QUARTER TRIM SPEAKER REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE UPPER BACK PANEL GARNISH

    A01E08P

    1. Detach the 4 claws and 5 clips and remove the upper back panel garnish.

  3. REMOVE REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)


    1. A01DXC8

      Operate the rear seat cushion lock hook release lever and pull up the rear seat cushion assembly LH to detach the hook.

      Text in Illustration
      A01E2TX Pull Up
      A01DZ8Z Release
    2. A01E1XM

      Detach the 2 hooks and rear seat cushion assembly LH.

  4. REMOVE REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)

    Tech Tips

    Use the same procedures described for the LH side.

  5. REMOVE LOWER BACK PANEL GARNISH

    A01E0WX

    1. Detach the 6 claws, 2 guides and 5 clips and remove the lower back panel garnish.

  6. REMOVE REAR SEATBACK ASSEMBLY


    1. A01DV2O

      Remove the 2 bolts.

    2. Lift up the rear seatback assembly in the direction indicated by the arrow to detach the 2 hooks from the vehicle body. Then remove the rear seatback assembly.

      Note

      Be careful not to damage the vehicle body.

  7. REMOVE FRONT DOOR SCUFF PLATE LH

    A01DW2EE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the front door scuff plate.

    2. Using a moulding remover, detach the 4 clips and 8 claws and remove the front door scuff plate.

  8. REMOVE FRONT DOOR WEATHERSTRIP LH

    A01DYLA

    1. Remove the front door opening trim.

  9. REMOVE QUARTER INSIDE TRIM BOARD LH

    A01E1ZG

    1. Remove the bolt and disconnect the front seat outer belt floor anchor.

    2. A01DZ5N

      Detach the 4 claws, 3 guides and 7 clips and remove the quarter inside trim board.

  10. REMOVE REAR SPEAKER ASSEMBLY


    1. A01E1Z0

      Disconnect the connector.

    2. Remove the 3 screws and speaker.