AIRBAG SYSTEM(w/o Occupant Classification System) DATA LIST / ACTIVE TEST

  1. READ DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the GTS to the DLC3.

    2. Turn the power switch to on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / SRS Airbag / Data List.

    5. According to the display on the GTS, read the Data List.

      Body Electrical > SRS Airbag > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Display Type Information

      Display Type Information

      LR

      LR: Display is indicated by LH / RH

      -

      Number of Past DTC

      Number of Past DTCs

      Min.: 0, Max.: 255

      0

      -