U760E AUTOMATIC TRANSAXLE FLUID REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the automatic transaxle fluid replacement are shown below.

PROCEDURE

1. REMOVE FRONT FENDER APRON SEAL LH

   Click here

2. REPLACE AUTOMATIC TRANSAXLE FLUID

   
   

   1. Lift the vehicle. [#1]

      Note

      Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure the tilt angle from the front to rear and side to side of the vehicle is within +/- 1°).

   2. 

      Remove the refill plug and gasket from the rear transaxle cover sub-assembly. [#2]

   3. 

      Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly. [#3]

   4. 

      *1	No. 1 Transmission Oil Filler Tube

      Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle oil pan sub-assembly and drain the automatic transaxle fluid. [#4]

   5. 

      Measure the amount of automatic transaxle fluid drained. [#5]

      Tech Tips

      Add the same amount of automatic transaxle fluid in step [#8].

   6. Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle oil pan sub-assembly. [#6]

      Torque:

      0.8 N*m  { 8 kgf*cm, 7 in.*lbf }

   7. 

      Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transaxle oil pan sub-assembly. [#7]

      Tech Tips

      Reuse the old gasket as the overflow plug will be removed again to adjust the automatic transaxle fluid level.

   8. 

      Add automatic transaxle fluid to the refill hole using the same amount of automatic transaxle fluid drained in step [#5]. [#8]

      Note

      Use Toyota Genuine ATF WS.

   9. 

      Temporarily install the gasket and refill plug to avoid automatic transaxle fluid spillage. [#9]

      Tech Tips

      Reuse the old gasket as the refill plug will be removed again to adjust the automatic transaxle fluid level.

   10. Lower the vehicle. [#10]

   11. Start the engine. [#11]

   12. Slowly move the shift lever from P to D, and then back to P. [#12]

       Tech Tips

       
       

       • Slowly move the shift lever to circulate the automatic transaxle fluid through each part of the automatic transaxle assembly.

       • Keep the shift lever in each position for approximately 3 seconds.

   13. Allow the engine to idle for 30 seconds to warm it up. [#13]

   14. Turn the ignition switch off. [#14]

   15. Repeat steps [#1] to [#14].

   16. Repeat steps [#1] to [#10].

3. ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID

   Click here

4. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the GTS)

   Click here

5. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the GTS)

   Click here

6. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL

   Click here

7. REBUILD WORK

   Click here

8. INSTALL FRONT FENDER APRON SEAL LH

   Click here

9. ATF THERMAL DEGRADATION ESTIMATE RESET

   Note

   Perform ATF Thermal Degradation Estimate Reset if approximately 50% or more of the ATF has been replaced during a repair or a similar operation.

   Click here