UPPER INSTRUMENT PANEL(for Sedan) INSTALLATION

PROCEDURE

  1. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY

    1. When installing a new instrument panel sub-assembly:

      1. Immediately before installing the upper instrument panel assembly, twist and cut off the portion as shown in the illustration.

        B334381

    2. Push the upper instrument panel assembly in the direction indicated by the arrow (1) to engage the 5 guides.

      B352221N01

    3. Push the upper instrument panel assembly in the direction indicated by the arrow (2) to engage the 6 clips to install the upper instrument panel assembly.

    4. Install the bolt <A>.

      20 N*m

      204 kgf*cm

      15 ft.*lbf

    5. Install the 2 clips.

    6. Connect each connector.

  2. CONNECT NO. 2 INSTRUMENT PANEL WIRE

    Click hereClick here

  3. INSTALL FRONT PILLAR GARNISH RH

    Tip:

    Use the same procedure as for the LH side.

  4. INSTALL NO. 2 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    1. Engage the 11 clips to install the No. 2 instrument panel register sub-assembly.

  5. INSTALL INSTRUMENT SIDE PANEL RH

    1. B350643N01

      Push the instrument side panel RH in the direction indicated by the arrow (1) to engage the 2 guides and push it in the direction indicated by the arrow (2) to engage the 6 clips to install the instrument side panel RH.

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

  7. INSTALL FRONT PILLAR GARNISH LH

    w/o Curtain Shield Airbag:Click here

    w/ Curtain Shield Airbag:Click here

  8. INSTALL COMBINATION METER ASSEMBLY

    Click here

  9. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    1. B350638

      Engage the 9 guides and 4 clips to install the instrument cluster finish panel assembly as shown in the illustration.

  10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    1. Connect each connector.

    2. Engage the 8 claws and 5 clips to install the center instrument cluster finish panel sub-assembly.

  11. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    1. Engage the guide, 12 claws and 10 clips to install the No. 1 instrument panel garnish sub-assembly.

      B350636

  12. INSTALL NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    1. Engage the 2 claws and 4 clips to install the No. 1 instrument panel register sub-assembly.

  13. INSTALL INSTRUMENT SIDE PANEL LH

    1. B350633N01

      Push the instrument side panel LH in the direction indicated by the arrow (1) to engage the 2 guides and push it in the direction indicated by the arrow (2) to engage the 6 clips to install the instrument side panel LH.

  14. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  15. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    1. B350631

      Engage the claw and 2 clips to install the No. 2 instrument panel garnish sub-assembly as shown in the illustration.

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  17. INSPECT SRS WARNING LIGHT

    Click hereClick here