NETWORK GATEWAY ECU(for LHD) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click hereClick here

  4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  5. REMOVE ECU INTEGRATION BOX RH

    1. B421013

      Disconnect each connector and detach the wire harness clamp.

    2. B421014

      Remove the 2 nuts and bolt and ECU integration box RH.

  6. REMOVE NETWORK GATEWAY ECU

    1. E332644C01
      V100155

      Protective Tape

      Using a screwdriver, insert it to the ECU integration box RH and detach the 2 claws.

      Tip:

      Tape the screwdriver tip before use.

    2. Pull out and remove the network gateway ECU from the ECU integration box RH.