REAR NO. 1 SEAT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tip:

  • Use the same procedure for the LH side and RH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR DOOR SCUFF PLATE LH

    Click hereClick here

  2. REMOVE INNER SEAT TRACK BRACKET COVER LH

    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. B220737

      Detach the 2 claws and 3 guides, and then remove the cover.

  3. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH

    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. B220738

      Detach the 2 claws and 2 guides, and then remove the cover.

  4. REMOVE REAR SEAT INNER TRACK BRACKET COVER LH

    1. B220739

      Detach the 3 claws and guide, and then remove the cover.

  5. REMOVE REAR NO. 1 SEAT ASSEMBLY

    1. B220740

      Detach the 2 claws and wire harness clamp.

    2. Disconnect the connector.

    3. Lift up the seat track adjusting handle and move the seat to the foremost position.

    4. B220866

      Remove the 2 bolts.

    5. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    6. B220867

      Remove the 2 bolts.

    7. Operate the rear back lock control lever RH and fold down the seatback.

    8. Remove the rear No. 1 seat assembly from the vehicle.

      Note:

      Be careful not to damage the vehicle body or rear center seat assembly.