TELEVISION CAMERA(for Rear) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Rear television camera assembly (w/ Parking assist monitor system)

  • Parking assist monitor system initialization

  • Rear television camera assembly optical axis (Back camera position setting)

 Parking assist monitor system

Click here

Rear television camera assembly (w/ Panoramic view monitor system)

  • Rear television camera view adjustment

  • Rear television camera assembly optical axis (Back camera position setting)

 Panoramic view monitor system

Click here

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

    Click here

  2. REMOVE REAR TELEVISION CAMERA ASSEMBLY WITH WIRE


    1. B0088CS

      Disconnect the connector.

    2. Disengage the clamp.

    3. B0089BDC01
      B00847Z Remove in this Direction

      Disengage the 2 claws to remove the rear television camera assembly with wire as shown in the illustration.

  3. REMOVE TELEVISION CAMERA WIRE


    1. B0084C5

      Disconnect the connector to remove the television camera wire.

  4. REMOVE REAR TELEVISION CAMERA ASSEMBLY