HEATED OXYGEN SENSOR(for Sensor 1) INSTALLATION

PROCEDURE

  1. INSTALL HEATED OXYGEN SENSOR (Sensor 1)

    1. A327067C01

      *a

      Length of SST 30 mm (1.18 in.)

      *b

      Length of Torque Wrench 260 mm (10.2 in.)

      Using SST, install the heated oxygen sensor (sensor 1) to the exhaust manifold.

      09224-00010

      without SST [Torque (N*m (kgf*cm, ft.*lbf))]

      50 N*m

      510 kgf*cm

      37 ft.*lbf

      with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]

      45 N*m

      459 kgf*cm

      33 ft.*lbf

      Note:

      If the heated oxygen sensor (sensor 1) has been struck or dropped, replace it.

      Tip:

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click hereClick here

    2. Engage the 2 wire harness clamps.

    3. Connect the heated oxygen sensor (sensor 1) connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here